In-Lite CABLE CAP MEDIUM for 10/2 Cable – Pack of 20

In-Lite CABLE CAP MEDIUM for 10/2 Cable – Pack of 20

Twenty protective end caps for safely and neatly finishing the two conductors at the cut end of In-Lite 10/2 system cable

CABLE CAP MEDIUM is the correct finishing cap for In-Lite 10/2 heavy-gauge system cable. The pack contains twenty individual caps, enough to finish ten cut ends because the two separated conductors each require their own cap.

How and where to use it

The main cable should be installed as a linear run or an approved branch, never as a loop between transformer outputs. At the final end, separate the last three centimetres of cable, leave the insulation in place and fit a cap over each conductor. This creates the neat, serviceable finish intended by the manufacturer.

Important compatibility and installation limits

CABLE CAP MEDIUM is for 10/2 cable only. Use CABLE CAP STANDARD on 14/2 cable. The correct number of caps may already be supplied with a new transformer or cable bundle, so additional packs are most useful for expanded, altered or professionally stocked installations.

Technical information

• Compatibility: In-Lite 10/2 two-core system cable
• Pack quantity: 20 individual caps
• Caps required per cable end: 2
• Finish capacity: up to 10 cable ends
• Installation: separate conductors by approximately 30mm
• Do not remove conductor insulation
• Reusable for later cable changes when undamaged

Plan the complete In-Lite cable system

Use with the heavier options in the In-Lite CBL cable range, especially on longer or higher-load correctly designed routes.

Keep every connector reasonably accessible and test the complete circuit before covering cable routes or finishing hard landscaping. Contact us with the transformer, cable type and fitting list if you would like help checking compatibility.

Check the exact system connection before ordering

In-Lite CABLE CAP MEDIUM for 10/2 Cable – Pack of 20 should be selected by its actual connection and job in the circuit, not by appearance alone. In-Lite main cable, fixture-side extension leads and family-specific drivers are not interchangeable simply because two plugs look similar. Check the model name and manufacturer’s instructions before ordering.

Lay out the route before burying or enclosing anything. Keep serviceable connections accessible, protect cable from sharp edges and future digging, and test the complete lighting section before the final surface is reinstated.

Matching main cable

Choose the cable size stated in this cap listing. Standard caps are for 14/2 and medium caps for 10/2.

In-Lite CBL Two-Wire Garden Lighting System Cable