In-Lite SPLITTER TRIPLE Three-Way Fixture Cable Splitter

In-Lite SPLITTER TRIPLE Three-Way Fixture Cable Splitter

SPLITTER TRIPLE creates three compatible fixture-side connections from one EASY-LOCK point. It is useful for a small group of low-load fittings installed close together, where one organised connection is neater than several separate EASY-LOCK positions on the main cable.

How and where to use it

Connect the SPLITTER TRIPLE after a genuine EASY-LOCK and plug in up to three compatible fitting mini-connectors. It can also form part of the approved arrangement for sharing one light sensor between multiple compatible non-smart transformers. Keep the connector accessible so every branch can be checked or changed later.

Important compatibility and installation limits

The total compatible fixture load connected through the SPLITTER TRIPLE and its EASY-LOCK must remain within the manufacturer’s stated 10W limit. Do not treat the three outlets as three independent transformer circuits. It must not be used to split EVO FLEX, which requires its own driver and dedicated approved connection.

Verified technical information

• Fixture outlets: 3
• Connection point: after one EASY-LOCK
• Maximum stated combined fixture load: 10W
• Alternative use: compatible light sensor sharing
• Maximum stated transformers on sensor arrangement: 5
• Suitable for accessible above- or below-ground placement
• Not compatible with EVO FLEX fixture splitting

Plan the complete In-Lite cable system

Choose the two-way SPLITTER where only two lights are required, and use a genuine EASY-LOCK at the main cable.

Keep every connector reasonably accessible and test the complete circuit before covering cable routes or finishing hard landscaping. Contact us with the transformer, cable type and fitting list if you would like help checking compatibility.

Check the exact system connection before ordering

In-Lite SPLITTER TRIPLE Three-Way Fixture Cable Splitter should be selected by its actual connection and job in the circuit, not by appearance alone. In-Lite main cable, fixture-side extension leads and family-specific drivers are not interchangeable simply because two plugs look similar. Match the product name, supplier SKU and manufacturer reference to the current installation instructions.

Lay out the route before burying or enclosing anything. Keep serviceable connections accessible, protect cable from sharp edges and future digging, and test the complete lighting section before the final surface is reinstated.

Compatible and related In-Lite products

For the same project, compare In-Lite SPLITTER Two-Way Fixture Cable Splitter, In-Lite EASY-LOCK Fixture-to-System Cable Connector, In-Lite CABLE CAP MEDIUM for 10/2 Cable – Pack of 20, and In-Lite CABLE CAP STANDARD for 14/2 Cable – Pack of 20. These direct links make it easier to check the precise size, load, finish and connection of each item rather than relying on a similar-looking photograph or family name. If this is a replacement, compare the label and existing connection before assuming that two parts from the same family are interchangeable.