In-Lite CABLE CAP STANDARD for 14/2 Cable – Pack of 20

In-Lite CABLE CAP STANDARD for 14/2 Cable – Pack of 20

Twenty protective end caps for safely and neatly finishing the two conductors at the cut end of In-Lite 14/2 system cable

CABLE CAP STANDARD is the correct finishing cap for the two separated conductors at the end of In-Lite 14/2 system cable. This pack contains twenty caps, enough to finish ten cut cable ends when one cap is fitted to each conductor.

How and where to use it

An In-Lite main cable can finish at any suitable point; it does not need to return to the transformer or form a loop. The exposed end must, however, be finished properly. Separate the last three centimetres of the two-core cable and push one cap onto each insulated conductor. Do not strip away the insulation.

Important compatibility and installation limits

These caps are sized for 14/2 cable. Use CABLE CAP MEDIUM for the thicker 10/2 system cable. New transformers and cable bundles may already include the caps required for the initial installation, so check what is supplied before ordering an additional pack.

Technical information

• Compatibility: In-Lite 14/2 two-core system cable
• Pack quantity: 20 individual caps
• Caps required per cable end: 2
• Finish capacity: up to 10 cable ends
• Installation: separate conductors by approximately 30mm
• Do not remove conductor insulation
• Reusable for later cable changes when undamaged

Plan the complete In-Lite cable system

Use with the correct In-Lite CBL cable and plan every branch and end point before covering the route.

Keep every connector reasonably accessible and test the complete circuit before covering cable routes or finishing hard landscaping. Contact us with the transformer, cable type and fitting list if you would like help checking compatibility.

Check the exact system connection before ordering

In-Lite CABLE CAP STANDARD for 14/2 Cable – Pack of 20 should be selected by its actual connection and job in the circuit, not by appearance alone. In-Lite main cable, fixture-side extension leads and family-specific drivers are not interchangeable simply because two plugs look similar. Check the model name and manufacturer’s instructions before ordering.

Lay out the route before burying or enclosing anything. Keep serviceable connections accessible, protect cable from sharp edges and future digging, and test the complete lighting section before the final surface is reinstated.

Matching main cable

Choose the cable size stated in this cap listing. Standard caps are for 14/2 and medium caps for 10/2.

In-Lite CBL Two-Wire Garden Lighting System Cable