In-Lite EASY-LOCK Fixture-to-System Cable Connector

In-Lite EASY-LOCK Fixture-to-System Cable Connector

The genuine weatherproof connector used to attach an In-Lite 12V fitting to the main 10/2 or 14/2 system cable at the chosen position

EASY-LOCK is the genuine connector that attaches an In-Lite fitting to the main low-voltage system cable at the chosen point. Its contacts pierce the cable insulation as the threaded cap is tightened, while the protective gel helps shield the connection from moisture and outdoor conditions.

How and where to use it

Place the correct cable guide over genuine In-Lite system cable, seat it in the EASY-LOCK and tighten the cap fully so the contacts enter the conductors. Then connect the fitting through its push-fit mini-connector. The connection can be positioned above or below ground and moved later if the lighting layout changes.

Important compatibility and installation limits

An EASY-LOCK is supplied with each new In-Lite light, so this product is usually required as a genuine replacement rather than an extra for every fitting. It is not a main-cable branch connector and must never be connected directly to 230–240V mains. Use only with the correct In-Lite system components and inspect the contacts if a moved fitting does not illuminate.

Technical information

• Purpose: connect one fitting to the main In-Lite cable
• Connection: insulation-piercing contacts and fixture mini-connector
• Protective gel for outdoor moisture resistance
• Can be positioned above or below ground
• Can be repositioned when the layout changes
• Normally supplied with each new In-Lite fitting
• Manufacturer part number: 11400500

Plan the complete In-Lite cable system

Connect to genuine In-Lite CBL system cable and add a CBL-EXT CORD only on the fixture side when extra reach is needed.

Keep every connector reasonably accessible and test the complete circuit before covering cable routes or finishing hard landscaping. Contact us with the transformer, cable type and fitting list if you would like help checking compatibility.

Check the exact system connection before ordering

In-Lite EASY-LOCK Fixture-to-System Cable Connector should be selected by its actual connection and job in the circuit, not by appearance alone. In-Lite main cable, fixture-side extension leads and family-specific drivers are not interchangeable simply because two plugs look similar. Check the model name and manufacturer’s instructions before ordering.

Lay out the route before burying or enclosing anything. Keep serviceable connections accessible, protect cable from sharp edges and future digging, and test the complete lighting section before the final surface is reinstated.

Use with

EASY LOCK attaches a compatible fitting to the main system cable. Complete lights commonly include one already; buy another only when your installation or replacement needs it.

In-Lite CBL Two-Wire Garden Lighting System Cable · In-Lite CBL-EXT CORD Garden Light Extension Cable