Oase OptiMax 1000 GB Aquarium Water Pump

SKU: 42673
Brand

Product type

Aquarium water pump

GB article

42673

Rated supply

230 V / 50 Hz

Maximum water flow

1,000 L/h

Maximum head

1.30 m

Dimensions (L Ă— W Ă— H)

77 Ă— 52 Ă— 80 mm

Power cable

1.50 m

Pressure-side connection

17 mm connection

Suction-side connection

19 mm connection

Installation

Submerged or externally flooded below water level

Water type

Freshwater, Marine

Power consumption

12 W

Adjustable aquarium water pump with 1,000 L/h maximum flow and 1.30 m maximum head as separate ratings. GB article 42673; submerged or externally flooded installation below water level; not self-priming.

Representative manufacturer family photograph. See the product specifications and supplied-items details for Oase article 42673.

£39.83 (inc VAT)

The Oase OptiMax 1000 GB is an adjustable aquarium water pump for moving water in a suitable freshwater or marine setup. Its rated maximum water flow is 1,000 L/h and its separate maximum head is 1.30 m. It can be used for circulation or to drive a suitably matched aquarium filter. This is a water pump; it does not replace an air pump and diffuser.

Choose a pump for the whole circuit

The maximum flow is a pump rating, not a promise that 1,000 L/h will reach the outlet after water is lifted through hose, fittings and a filter. The maximum head is a separate limit, not a second rating achieved at the same time as maximum flow. Check the lift from the water surface, the route and bore of the plumbing, and the filter’s requirements when choosing the pump.

Use the adjustable flow control to suit the aquarium once the circuit is assembled. Consider the animals, plants and equipment as well as the volume of water: too strong a stream may disturb a small or gently planted setup, while a restricted or blocked intake can reduce circulation. The specifications are a starting point for selection; check the manufacturer’s pump curve and the installation duty where a particular delivered rate matters.

For comparison, the Oase OptiMax 800 is rated at 800 L/h maximum flow and 1.00 m maximum head. The 800 shares the same stated housing dimensions but has a lower rated maximum and lower power consumption. The right choice depends on the required duty.

Submerged or flooded external installation

The OptiMax 1000 can be used submerged or in the documented external flooded arrangement. For an external installation, the pump must sit below the aquarium water level with a properly supplied inlet and a water-filled pump chamber. It is not self-priming. A motor positioned outside the tank must still never be allowed to run without water inside the pump.

Secure the pipework, check joints for leaks and keep the intake supplied as the aquarium level changes. Use indoors, protect the surrounding area from leaks, keep electrical connections dry and arrange a cable drip loop. Disconnect aquarium electrical equipment from the mains before putting your hands in the water or opening the circuit. Follow the instructions supplied with the unit when assembling and restarting it.

Connections, adjustment and care

Check the inlet and outlet separately against the connection details in the table. The pressure-side and suction-side figures describe their respective connections; they are not the inside and outside diameters of one hose. Thread labels, where listed, are nominal thread sizes, so check the actual mating fitting before ordering hose or adapters.

If water delivery becomes weaker or the sound changes, isolate the equipment and inspect the intake, pipework and rotor for debris. Follow the pump instructions when opening the housing and cleaning the impeller; use water and a soft brush rather than household detergents. Reassemble carefully, make sure the circuit is filled and check for leaks before returning it to use.

Routine checks are especially useful after cleaning a filter, moving hose or topping up the aquarium. A pump moves water through the arrangement you give it; mechanical and biological filtration depend on the separate filter and media selected for that arrangement.

Specifications and what is supplied

Specification Detail
GB article 42673
Rated supply 230 V / 50 Hz
Maximum water flow 1,000 L/h
Maximum head 1.30 m
Power consumption 12 W
Dimensions (L Ă— W Ă— H) 77 Ă— 52 Ă— 80 mm
Power cable 1.50 m
Pressure-side connection 17 mm connection
Suction-side connection 19 mm connection
Installation Submerged or externally flooded below water level
Water type Freshwater / marine

This listing is for the OptiMax 1000 GB pump, article 42673, with its power cable and supplied mounting components. A complete filter, biological media, heater and air-pump kit are separate choices. Check the actual connections and any accessories needed for your layout before installation.

Browse other aquarium equipment when planning the rest of the system. A different OptiMax model can be compared for flow and head, but model names alone do not establish interchangeable spare parts.

Common questions

Is the maximum flow the rate delivered through my filter?

Not necessarily. Lift, hose, fittings and the connected filter affect the working flow. Use the separate maximum-flow and maximum-head figures as selection references, then check the pump curve for your duty.

Can the pump run without water?

No. The pump must stay filled with water, including when it is installed outside the aquarium below water level.

Will it supply air bubbles through a diffuser?

It is a water-circulation pump. An OxyMax air pump and appropriate airline and diffuser are separate equipment for aeration.

Oase OptiMax 1000 GB Aquarium Water Pump Reviews

Reviews

There are no reviews yet.

Be the first to review “Oase OptiMax 1000 GB Aquarium Water Pump”